Electrical data
型号Type | ||||||
额定测量电流Rated input IPN 主1000a | 20004 | 主30004 | 40000 | |||
测量范围Measure range lp 0~±2000A | 0~±4000A | 0~±5000A | 0~±60004 | |||
额定输出电流Rated output current Is ±200mA±0.4% | ±400mA±0.4% | ±600mA±0.4% | ±666mA±0.4% | |||
测量电阻范围RM Measure resister range | With±24V@lpN With±24V@lp | max max | 80Q 36Q | max300 max110 | max170 max50 | max 150 max50 |
转换比率Conversion ratio KN 1:5000 | 1:5000 | 1:5000 | 1:6000 | |||
电源电压Supply voltage Voo DC±24V(±5%) | ||||||
电流消耗Current consumption lo 35mA(@±24V)+Is | ||||||
绝缘耐压Galvanic isolation Vo 50Hz,1min,6KV | ||||||
线性度Linearity e1 <0.1%FS | ||||||
总体精度Overall accuraty X ±0.4% | ||||||
零点失调电流Offset current lo ±0.3mA | ||||||
零点失调电流温漂lor Offset current drift <+0.5m | ||||||
响应时间Response time TR @50A/μs,10%-90% <1μ S | ||||||
di/dt跟随精度di/dt accurately followed 50A/u | ||||||
频带宽度Frequenoy bandwidth-1db DC~100KHz | ||||||
工作环境温度TA Ambient operating temperature | -40~+85℃ | |||||
储存环境温度Ts -40~+125℃ Ambient storage temperature | ||||||
质量Massm =4.5kg | ||||||
执行标准Standards SJ20790-2000;JB/T 7490-2007 | ||||||
Dimensions of drawing(mm)
Remarks
1. When the current will be measured goes through a sensor,the currentwill be measured at the output end.(Note:The false wiring may result in the damage of the sensor)
2. The dynamic performance(di/dt and the response time)is the bestwhen the primary hole is fully
filled with thebus bar.
3. Custom design in the different rated inputcurrent and the output voltage are available.
| Classify | Title | Download |
|---|
Leave your contacts and our engineers will help you to find the solution you are looking for.
Open loop current sensor based on the principle of Hall-effect. It can measure the AC signal current under the condition of electrical isolation and convert it into DC signal output.
KNOW MORE
Open loop current sensor based on the principle of Hall-effect. It can measure the AC signal current under the condition of electrical isolation and convert it into DC signal output.
KNOW MORE
Op en loop current sensor based on the principle of Hall-effect. It can measure the AC signal current under the condition of electrical isolation and convert it into DC signal output.
KNOW MORE
Open loop current sensor based on the principle of Hall-effect. It can measure the AC signal current under the condition of electrical isolation and convert it into DC signal output.
KNOW MORE
Open loop current sensor based on the principle of Hall-effect. It can measure the AC signal current under the condition of electrical isolation and convert it into DC signal output.
KNOW MORE
Open loop current sensor based on the principle of Hall-effect. It can measure the AC signal current under the condition of electrical isolation and convert it into DC signal output.
KNOW MORE
The current sensor using the principle of electromagnetic induction can measure the AC signal current under the condition of electrical isolation, and output 4-20mA DC current output proportional to the effective value of the measured current. They require only a two-wire connection and do not require a separate loop power supply.
KNOW MORE
The current sensor using the principle of electromagnetic induction can measure the AC signal current under the condition of electrical isolation, and output 4-20mA DC current output proportional to the effective value of the measured current. They require only a two-wire connection and do not require a separate loop power supply.
KNOW MORE
Open loop current sensor based on the principle of Hall-effect. It can measure the AC signal current under the condition of electrical isolation and convert it into DC signal output.
KNOW MORE
The current sensor using the Hall effect open-loop principle can measure DC, AC, pulse and various irregular waveforms of current under the condition of electrical isolation.
KNOW MORE
Open loop current sensor based on the principle of Hall-effect.It can be used for measuring AC,DC,pulsed and mixed current.
KNOW MORE
A new type of current sensor based on the principle of magnetic modulation has good stability of small current, high insulation between primary and secondary, and strong anti-interference ability. After signal conversion, it can be directly collected and accepted by PLC, secondary instrument and other acquisition devices, and is used in signal system, line detection, leakage monitoring system, current difference measurement.
KNOW MORE
A new type of current sensor based on the principle of magnetic modulation, which can measure the current of mA level small signal DC under the condition of electrical isolation.
KNOW MORE
A new type of current sensor based on the principle of magnetic modulation ,which can measure the current of mA level DC small signal under the condition of electrical isolation.
KNOW MORE
D-FS050LD/60 series DC leakage current sensor is a new type of current sensor developed by magnetic modulation principle. It has good stability of small current and high insulation between primary and secondary. Used in signal system, line detection, leakage monitoring system, current difference measurement.
KNOW MORE
D-FS100LD/20C series DC leakage current sensor is a new type of current sensor developed by magnetic modulation principle. It has good stability of small current, high insulation between primary and secondary, and strong anti-interference ability. After signal conversion, it can be directly collected and accepted by PLC, secondary instrument and other acquisition devices, and is widely used in signal system, line detection, leakage monitoring system, current difference measurement.
KNOW MORE
Applying Hall effect and closed-loop Hall measurement principle, after TRCSM calculation, the measured current is converted into a DC current or voltage measurement module proportional to the output of the primary current, and the mixed current such as AC and DC is measured, and the primary and secondary sides are highly insulated. It has the characteristics of high accuracy, high linearity, high integration, small size, simple structure, easy installation, long-term stability and adapt to various working environments. Widely used in electric power, petroleum, coal, chemical, railway, communication, building automation and other industries of electrical equipment system control and testing.
KNOW MORE
Using Hall effect and open-loop measurement principle, after TRMS calculation, the measured current is converted into DC current or voltage output proportional to the primary current, and the current sensor can measure DC, AC, pulse and various irregular waveforms of current under the condition of electrical isolation. It has the characteristics of high accuracy, high linearity, high integration, small size, simple structure and long-term stability.
KNOW MORE
Using Hall effect and open-loop measurement principle, after TRMS calculation, the measured current is converted into DC current or voltage output proportional to the primary current, and the current sensor can measure DC, AC, pulse and various irregular waveforms of current under the condition of electrical isolation. It has the characteristics of high accuracy, high linearity, high integration, small size, simple structure and long-term stability.
KNOW MORE
The LTR5 series sensor is an open-loop current sensor based on the Hall principle that can measure DC, AC, pulse and various irregular currents. The output of the sensor can truly reflect the real waveform of the energized conductor.
KNOW MORE
Hi! Welcome back.
How are you doing?
Let’s talk! We’ll provide the perfect solution for you！
Shanghai Freesor Sensor Technology Co. ,Ltd. was founded in 2005 by a number of overseas returnees with rich experience. It is a high-tech enterprise integrating design, research and development, production and sales.
Sales Center Add: Room 1405-1, Building B, 333 Haiyang 1st Road, Pudong New Area, Shanghai
Factory Add:Building 4, Keland Smart Energy Industrial Park, Guangming District, Shenzhen, Guangdong Province, China.
English
Russian
Chinese
