FCT series Integrated current sensor

优势特征：Advantages：

l 应用Hall感应原理的开环型电流传感器

Open loop current sensor using Hall induction principle

l 单电源5V供电

Single power supply 5V

l 支持单向，双向输出

Support unidirectional, bidirectional output

l 模拟信号输出

 Analog signal output

l 原边测量电流范围可从±50A-±250A

The measuring current range of the primary side can be from ±50A to ±250A

l 传感器工作温度范围：Sensor operating temperature range: -40 °C to +125°C

(150A为-40 °C to +105°C；200A/250A为-40 °C to +85°C)

l 零点输出电压：Zero output voltage:

-xR：偏置QVO与供电电源VCC等比例输出，增益Gain固定 Bias the output of QVO and VCC in equal proportion, and the Gain is fixed

VQVO=VCC/2 or VCC/10

-xF：偏置QVO和增益Gain均固定  Indicates that the bias QVO and Gain are both fixed

VQVO=2.50 or 0.50

l 良好的精度、线性度以及温漂 Good accuracy, linearity and temperature drift

l 低内阻（100μΩ) , 可有效控制发热功耗 Low internal resistance (100μΩ), can effectively control the heat consumption

l 内置断线、过电压（OVD)、欠电压(UVD)检测 Built-in broken line, overvoltage (OVD), undervoltage (UVD) detection

l 输出电压钳位 Output voltage clamp

l 产品符合UL认证, 符合AECQ100  Products comply with UL certification and comply with AECQ100 

产品应用：Product Application

l EV/HEV电机控制器 EV/HEV Motor controller

l 变频器 Inverter

l DC/DC

通用电气参数 General electric parameter

VCC = 5.0V 时的直流工作参数（除非另有说明），TA 在规定温度范围内。

Dc operating parameters at VCC = 5.0V (unless otherwise specified), TA within the specified temperature range.

注意事项：Notice

1. 错误的接线可能导致传感器损坏。传感器接 5V 电源后，被测电流从传感器箭头方向穿过，即可在 输出端测得相对应的电压值。

Incorrect wiring may cause damage to the sensor. After the sensor is connected to a 5V power supply, the measured current passes through the arrow direction of the sensor, and the corresponding voltage value can be measured at the output end.

2. -BR：输出电压 VOUT 是与供电电压 VCC 成正比例关系，VOUT   = VCC⁄2 + 2 × Ip⁄I               ，供电电压变

化，会引起 VOUT 等比例的变化。

-BR: The output voltage VOUT is directly proportional to the power supply voltage VCC, VOUT = VCC⁄2 + 2 × Ip⁄I, the change of the power supply voltage will cause the VOUT proportional change.

例如：VCC 范围 4.75V~5.25V；对应 0A 下的静态输出电压 VQVO 输出范围为 2.375V~2.625V 。满 量程 VOUT(IPMAX)的输出范围为 4.375V~4.625V。

                   For example, the VCC ranges from 4.75V to 5.25V. The corresponding static output voltage VQVO at 0A ranges from 2.375V to 2.625V. The output range of full-scale VOUT(IPMAX) is 4.375V to 4.625V.